60
When the key is pressed after setting the “before
set value”(SET2), is blinking displayed.
As the value of “near zero” memorized at present is
displayed when the key is pressed again, please set
the value of “near zero” similarly.
Press the key. is displayed, and
please set to stand-by condition by pressing the key.
The various setting modes of weigh-in/weigh-out
measurement are finished.
● The setting of the target value, fall, pre-set value and near zero becomes effective only when the function F-20 is set in “7” (weigh-in
mode) and “8” (weigh-out mode).
Near zer
[A]
[B]
To Next Page
Loading...
Need help?
General
