MIR MiR250 Dynamic - Safety; System Manufacturer

3. Safety
MiR250 Dynamic Integrator Manual (en) 09/2023 - v.2.1 ©Copyright 2020–2023: Mobile Industrial Robots A/S. 24
3. Safety
Read the information in this section before powering up and operating MiR250 Dynamic.
Pay particular attention to the safety instructions and warnings.
NOTICE
Mobile Industrial Robots disclaims any and all liability if MiR250 Dynamic or its
accessories are damaged, changed, or modified in any way. Mobile Industrial Robots
cannot be held responsible for any damages caused to MiR250 Dynamic, accessories,
or any other equipment due to programming errors or malfunctioning of MiR250
Dynamic.
MiR250 Dynamic is partly completed machinery, and there are steps you need to take before it
can be put into operation.
This manual does not cover instructions for designing, installing, or operating a complete robot
system, and it does not cover local legalization. Thus, this manual does not guarantee a safe
robot system but is only an informative document.
For more information about commissioning and creating a risk assessment see the
guides MiR Commissioning Guide and Risk Assessment Guide. You can find these guides
on MiR Support Portal.
3.1 System manufacturer
A system manufacturer (for example an integrator) designs and commissions the robot system,
including but not limited to MiR250 Dynamic, top modules, and other accessories such as
MiRCharge48V.
It is the system manufacturer's responsibility to ensure that the robot system complies with local
legislation and that any significant hazards have been adequately reduced. This includes, but is
not limited to:
l
Performing a risk assessment
l
Implementing risk reduction means, such as floor markings and other information for use
l
Providing instructions for the end-user