Configuring Softkeys
7.28 None Key
Use the following procedure to delete a key’s functionality on the 6915 IP phone.
Deleting a Key’s Function Using the Mitel Web UI
1. Click on Operation > Softkeys and XML.
2. Choose the key you want to delete from the phone.
3. In the Type field, select None.
4. Click Save Settings.The key function is deleted from the IP phone memory.
7.29 State-Based Softkeys
On the 6915 bottom softkeys, you can configure a specific state to display when a softkey is being used.
The following table describes the states available to configure for the softkeys.
State Description
Idle The phone is not being used.
Connected The current line is in an active call (or the call is on
hold).
Incoming The phone is ringing.
Outgoing The user is dialing a number, or the far-end is
ringing.
Busy The current line is busy because the line is in use
or the line is set as DND.
The following table identifies the applicable default states for each softkey type on the IP phone.
Version 1.0
107 User Guide
To Next Page
Loading...
