Configuring Softkeys
10. Click Save Settings.
11. Click on Reset, then click Restart to restart the IP phone and apply the changes.
12. Click Save Settings.
13. Click Reset, then click Restart to restart the IP phone and apply the changes.
Utilizing the Park Call/Pickup Parked Call Feature Using the IP Phone UI
Use the following procedure on the IP phone to park a call and pick up a parked call.
Parking a Call
1. While on a live call, press the Park key.
2. Perform the following for your specific server:
If the call is parked successfully, the response is either a greeting voice confirming that the call was
parked, or a hang up occurs. The parked call party hears music on hold.
3. If the call fails, you can pick up the call (using the next procedure) and press the Park key again to retry
Step 2.
Picking Up a Parked Call
1. Pick up the handset on the phone.
2. Enter the extension number where the call was parked.
3. Press the Pickup key.If the call pick up is successful, you are connected with the parked call.
7.11 Last Call Return Key
Using the Mitel Web UI, you can configure the Last Call Return function on a key. If you configure Last Call
Return on a key, and a call comes into your phone, after you are finished with the call and hang up, you
can press the key configured for Last Call Return and the phone dials the last call you received. When you
configure an Last Call Return key, the label LCR displays next to that key on the IP phone.
Configuring a Last Call Return Key Using the Mitel Web UI
1. Click on Operation > Softkeys and XML.
Version 1.0
91 User Guide
To Next Page
Loading...
