Additional Features
12
This chapter contains the following sections:
• Display DTMF Digits
• Play Call Waiting Tone
• Stuttered Dial Tone
• XML Beep Support
• Status Scroll Delay
• Switch UI Focus to Ringing Line
• Call Hold Reminder During Active Calls
• Call Hold Reminder (on single hold)
• Call Waiting Tone Period
• Preferred Line and Preferred Line Timeout
• Goodbye Key Cancels Incoming Calls
• Message Waiting Indicator
• Incoming Intercom Call Features
• Group RTP Paging
• Shared Call Appearance (SCA) Call Bridging
• Star Codes
• Other Features
This section describes additional features you can use on the 6915 phone.
12.1 Display DTMF Digits
A feature on the 6915 phone allows users to enable or disable DTMF (dual-tone multi-frequency) digits to
display to the IP phone when using the dialpad to dial, or when dialing from a softkey.
DTMF is the signal sent from the phone to the network that you generate when you press the phone’s
touch keys. This is also known as touchtone dialing. Each key you press on your phone generates two
tones of specific frequencies. One tone is generated from a high-frequency group of tones and the other
from a low frequency group.
If you enable the Display DTMF Digits parameter, the digits you are dialing from the dialpad or softkey
display to the IP phone’s LCD display. This parameter is disabled by default (no digits display when
dialing).
You can enable the Display DTMF Digits parameter using the Mitel Web UI.
Version 1.0
User Guide 166
To Next Page
Loading...
