Additional Features
12.6 Switch UI Focus to Ringing Line
You can configure a feature on the 6915 that controls the behavior of the phone when it receives an
incoming call when it is already in a connected call. When a call comes into the phone, and the phone is
already on a connected call, the phone switches focus to the ringing line to enable the user to see who is
calling them. You can turn off this functionality so that the phone stays focused on the connected call. You
can do this using the Switch Focus to Ringing Line parameter in the Mitel Web UI.
Configuring Switch Focus to Ringing Line
1. Click on Basic Settings > Preferences > General.
2. The Switch Focus to Ringing Line field is enabled by default. To disable this field, uncheck the box.
3. Click Save Settings to save your settings.
12.7 Call Hold Reminder During Active Calls
The IP phones allow you to enable or disable the ability for the phone to initiate a continuous reminder tone
on the active call when another call is on hold. For example, when this feature is enabled, and the call on
Line 1 is on hold, and then the you answer a call on Line 2 and stay on that line, a reminder tone is played
in the active audio path on Line 2 to remind you that there is still a call on hold on Line 1.
When this feature is disabled, a ring splash is heard when the active call hangs up and there is still a call
on hold.
You can enable or disable this feature using the Call Hold Reminder During Active Calls parameter in
the Mitel Web UI.
Configuring Call Hold Reminder During Active Calls
Version 1.0
User Guide 170
To Next Page
Loading...
