Managing Calls
a. If you selected Account mode in Step 5, you can enable/disable each account or all accounts as
applicable. You can enter different phone number for each enabled state.
b. If you selected Custom mode, you can enable/disable each account or all accounts as
applicable. You can enter different phone numbers for each enabled state.
c. If you selected Phone mode, all accounts are set to the same Call Forward configuration (All,
Busy, and/or No Answer) as Account 1 on the phone. In the Mitel Web UI, only Account 1 is
enabled. All other accounts are greyed out but use the same configuration as Account 1.
d. Using the Mitel Web UI, if you make changes to Account 1, the changes apply to all accounts on
the phone. Using the IP phone UI, if you make changes to any other account other then Account
1, the changes also apply to all accounts on the phone. When enabling a Call Forward state,
you must specify a phone number for the phone to Call Forward to. The number you specify
applies to all accounts of the same mode.
e. Number and name of accounts that display to this screen are dependent on the number and
name of accounts configured on the phone. The name for the account is specified by your
System Administrator. Contact your System Administrator for more information.
7. For the No Answer state, in the No. Rings field, enter the number of times that the account rings before
forwarding the call to the specified number. Valid values are 1 through 20. Default is 1.
8. When using the Account mode or Custom mode, you can enter a different number of rings for each
account. If you use the Mitel Web UI to change the Call Forward Key Mode to Phone, all accounts
synchronize to Account 1.
9. Click Save Settings. The changes takes affect immediately without a reboot.
Using Call Forward via the IP Phone UI
Once Call Forward is enabled on your phone, you can access the Call Forward menus by pressing a pre-
configured Call Forward key, or by selecting Options > Call Forward from the IP phone UI.
Call Forward in Account Mode
1. From the Home screen press the right navigation key to move to the Line Selection screen.
2. Highlight the desired account using the up and down navigation keys.
3. Press the left navigation key to go back to the Home screen.
4.
With the account in focus on Home screen, press the configured Call Fwd softkey or press ,
navigate to the Call Forward option and press the select button or Select softkey.The Call Forward
screen displays for the account you selected.
Version 1.0
User Guide 162
To Next Page
Loading...
