7 HK-ST SERIES
7.7 Mounting connectors
169
7
7.7 Mounting connectors
Both the one-touch lock fitting type and the screw fitting type can be used for the power connector. Mount the power
connector as shown in the following procedure.
One-touch lock fitting
1. Align the main key of the receptacle connector (motor side) with its groove on the plug connector (cable side), and insert
the plug into the receptacle.
2. While pushing the plug lightly, rotate the coupling nut clockwise until it clicks.
3. Pull the plug lightly to check that the plug does not come off.
One-touch fitting
component area
Screw fitting
component area
A. One-touch fitting (JL10 plug)
B. Screw fitting (JL04V plug)
To Next Page
Loading...
