Mitsubishi Electric MELSERVO-J5 HK-KT43W - Permissible Load for the Output Shaft

192
8 HK-RT SERIES
8.1 Standard specifications
Permissible load for the output shaft
The permissible load for the shaft is shown in the following. Do not subject the shaft to loads greater than the permissible
value. The value assumes that the load is applied independently.
In case where the load position changes, calculate the permissible radial load from the distance measured from the flange
mounting surface to the center of the load, and make the load equal to or less than the permissible radial load, referring to the
graph shown in the following.
Model Radial load Thrust load The graph of the relation between the load and the load
position
Load position
L [mm]
Load [N] Load [N]
HK-RT103(4)W
HK-RT153(4)W
HK-RT203(4)W
40 686 196
HK-RT353(4)W
HK-RT503(4)W
HK-RT703(4)W
55 980 490
Distance L from flange mounting
surface to load center
Radial load
Thrust load
360
380
400
420
440
460
500
480
010203040
Permissible load [N]
Distance L from flange surface [mm]
0
900
1000
1100
1200
0 1020304050
Permissible load [N]
Distance L from flange surface [mm]