Mitsubishi 4G1 series General Information

4G1 ENGINE (E-W) -
Oil Pump and Oil Pan
11A-10-4
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
"
E
A
OIL FILTER INSTALLATION
(1) Clean the filter mounting surface on the front case.
(2) Apply engine oil to the oil filter’s O-ring.
(3) Screw on the oil filter until the O-ring is seated on the
mounting surface. Then, give the oil filter one further
turn such that it is torqued to approximately 14 Nm.
Caution
The oil filter must be tightened using a commercially
available filter wrench. If the filter is tightened by hand
only, it will be insufficiently torqued, resulting in oil
leaks.
"
F
A
OIL FILTER INSTALLATION
(1) Clean the filter mounting surface on the front case.
(2) Apply engine oil to the O-ring of the oil filter.
(3) Screw the oil filter in and tighten the oil filter approximately
3/4 of a turn (approx. 16
±
4 Nm) from where the O-ring
has come into contact with the oil filter mounting surface.
Caution
The oil filter must be tightened using a commercially
available filter wrench. If the filter is tightened by hand
only, it will be insufficiently torqued, resulting in oil
leaks.
PWEE9520-D
E
Aug. 2000Mitsubishi Motors Corporation Revised
Bracket side

Mitsubishi 4G1 series Specifications

General

Brand	Mitsubishi
Model	4G1 series
Category	Engine
Language	English