Mitsubishi 4G1 series General Information

4G1 ENGINE (E–W) – Oil Pump and Oil Pan
11A-10-2
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
REMOVAL SERVICE POINT
AA" OIL PAN REMOVAL
(1) Remove the oil pan mounting bolts.
(2) Knock the special tool between the oil pan and cylinder
block as shown in the illustration.
(3) Tapping the side of the special tool, slide the tool along
the oil pan/cylinder block seal and thus remove the oil
pan.
INSPECTION
1. OIL PUMP
(1) Fit the rotor into the front case.
(2) Check the tip clearance using a thickness gauge.
Standard value: 0.06 – 0.18 mm
(3) Check the side clearance using a straight edge and
thickness gauge.
Standard value: 0.04 – 0.10 mm
(4) Check the body clearance using a thickness gauge.
Standard value: 0.10 – 0.18 mm
Limit: 0.35 mm
PWEE9520-E
E
Feb. 2001Mitsubishi Motors Corporation Revised
MD998727 MD998727

Mitsubishi 4G1 series Specifications

General

Brand	Mitsubishi
Model	4G1 series
Category	Engine
Language	English