Mitsubishi 4G1 series General Information

4G1 ENGINE (E-W) -
Crankshaft and Cylinder Block
11A-12-8
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
"
E
A
REAR OIL SEAL CASE INSTALLATION
(1) Apply liquid gasket to the rear oil seal case at the illustrated
position if it has no pre-formed gasket attached.
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent
Caution
Squeeze the liruid gasket uniformly so that there is
no break in the gasket nor is there too much gasket.
(2) Apply a suitable amount of engine to the entire periphery
of the oil seal lip and install the oil seal on the cylinder
block.
"
F
A
FLYWHEEL BOLT / DRIVE PLATE BOLT
INSTALLATION
(1) Clean off sealant, oil and deposits from the threaded
portion of the drive plate/adapter plate tightening bolts
and from the threaded holes on the crankshaft.
(2) Apply engine oil to the bolt flange and to the threaded
holes on the crankshaft.
(3) Apply sealant to the threaded portion of the bolt (if the
bolt is reused).
Specified sealant:
3M Nut Locking Part No. 4171 or equivalent
(4) Using the special tool, secure the drive plate and tighten
the bolts to the specified torque.
MD998781
PWEE9520-D
E
Aug. 2000Mitsubishi Motors Corporation Added

Mitsubishi 4G1 series Specifications

General

Brand	Mitsubishi
Model	4G1 series
Category	Engine
Language	English