4G1 ENGINE (E-W) -
Rocker Arms and Camshafts
11A-8-9
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
"
H
A
ROCKER COVER INSTALLATION
(1) Apply the specified sealant to the area shown, then fit
the rocker cover.
Specified sealant:
3M ATD part No. 8660 or equivalent
"
I
A
LASH ADJUSTER INSTALLATION
(1) Insert the lash adjuster to rocker arm, being careful not
to spill diesel fuel. Use the special tool to prevent adjuster
from falling while installing it.
Caution
If the lash adjuster is re-used, clean the lash adjuster.
(Refer to 11A-8-3.)
"
J
A
LASH ADJUSTER INSTALLATION
Caution
If the lash adjuster is re-used, clean the lash adjuster.
(Refer to 11A-8-6.)
Fit the lash adjuster onto the rocker arm without allowing
diesel fuel to spill out.
VALVE CLEARANCE ADJUSTMENT
<SOHC 12-VALVE>
(1) Position the No. 1 cylinder at top dead center on the
compression stroke.
(2) Adjust the valve clearance at the points shown in the
illustration.
(3) Loosen the adjusting screw locknut.
(4) Using a feeler gauge, adjust the valve clearance by turning
the adjusting screw.
Standard value: on cold engine
Intake 0.09 mm
Exhaust 0.17 mm
(5) While holding the adjusting screw with a screwdriver,
tighten the lock nut.
PWEE9520-D
E
Aug. 2000Mitsubishi Motors Corporation Revised
Lash adjuster
MD998443
Timing belt side
Thickness gauge
To Next Page
Loading...
Need help?
General
