12
12-19
Tightening torque (Unit: N·m {kgf·m})
Lubricant and/or sealant
Inspection before removal
Inspection: Backlash of each gear
• If the measurement exceeds the limit, replace the defective
part(s).
Inspection procedure
Inspection: Driven gear, Gear and case assembly
• Perform the following inspections. Replace the defective part(s)
as required.
(1) Difference between case depth and height of each gear
(2) Clearance between case and tooth tips of each gear
Mark Parts to be tightened Tightening torque Remarks
Bolt (oil pump cover mounting) 44 ± 4.9 {4.5 ± 0.5} –
Nut (idler shaft mounting) 69 ± 10 {7 ± 1}
Thread-locking
compound
Mark Points of application Specified lubricant and/or sealant Quantity
Nut thread Loctite 262 As required
Sliding parts of oil pump Engine oil As required
M
itsubishi 6M70 Engine Parts contact:
email: EngineParts@HeavyEquipmentRestorationParts.com
Phone: 269 673 1638
To Next Page
Loading...
