Mitsubishi 6M70 - Oil Jets, Oil Pan Disassembly and Assembly

12-16
Disassembly sequence
1 Drain plug
2 Oil pan
3 Check valve
4 Oil jet
: Locating pin
: Non-reusable parts
CAUTION
• The check valve has been tightened
using thread-locking compound
and so, may deform during remov-
al. Once removed, the check valve
must not be reused. Do not remove
the check valve unless defects are
evident.
Assembly sequence
Follow the disassembly sequence in reverse.
CAUTION
• If overtightened, the check valve will not operate properly, leading to engine seizure. Be sure to tighten
the check valve to the specified torque.
Tightening torque (Unit: N·m {kgf·m})
Lubricant and/or sealant
Mark Parts to be tightened Tightening torque Remarks
Drain plug 68 {7} –
Check valve 34 {3.5} –
Mark Points of application Specified lubricant and/or sealant Quantity
Crankcase mounting surface of oil pan ThreeBond 1207C As required
M
ITSUBISHI 6M70 OIL JETS, OIL PAN,