13-26
1. Diagnosis Procedure
• Perform the inspection in accordance with the following flowchart.
Vehicle in service shop
Read all (past and present) diagnosis codes by Multi-Use Tester. (See Gr00.)
Warning lamp lit
Was able to identify the fault?
Response to transient fault
(See Gr00.)
Perform inspection based on diagnosis codes. (See later section.)
Rectify or replace with new parts.
Clear stored diagnosis code. (See Gr00.)
Read diagnosis code(s) by Multi-Use Tester. (See Gr00.)
Code issued
End of inspection
Tes t d r i v e
NO
YES
No code issued
TROUBLESHOOTING <DIAGNOSIS USING Multi-Use Tester>
To Next Page
Loading...
