14-26
Removal sequence
• The automatic cooling fan coupling cannot be disassembled. If it is found faulty, replace the whole assembly.
Installation sequence
Follow the removal sequence in reverse.
CAUTION
• Be careful not to allow engine oil to smear the belt. A belt smeared with oil slips, resulting in reduced
cooling efficiency.
• When replacing the belts, replace them as a set to prevent differences in tension between the two belts.
• After installation, perform the inspection and adjustment of belt tension. (See “ON-VEHICLE INSPECTION AND
ADJUSTMENT.”)
1 Belt (for air conditioner)
2 Belt (for alternator)
3 Automatic cooling fan coupling
4 Cooling fan
5 Fan coupling
6 Torsional damper
*
a: Alternator
*
b: Cooler compressor
(for air conditioner)
*
c: Water pump
*
d: Crankshaft pulley
MITSUBISHI 6M70 COOLING FAN AND BELT
Mitsubishi 6M70 Engine Parts contact:
email: EngineParts@HeavyE
quipmentRestorationParts.com
Phone: 269 673 1638
To Next Page
Loading...
