Mitsubishi 6M70 - Flywheel Disassembly and Assembly

11-72
Disassembly sequence
Assembly sequence
Follow the disassembly sequence in reverse.
CAUTION
• The flywheel mounting bolt is tightened within the plastic region. The number of punch marks indicates
the number of times the bolt has been tightened. If there are 3 punch marks (tightened 3 times in the
past), replace the bolt.
1 Snap ring
2 Pilot bearing
3 Ring gear
4 Flywheel
5 Rear oil seal
6 Power steering oil hose
7 O-ring
8 Suction hose
9 Power steering oil pump
(See Gr37.)
10 O-ring
11 O-ring
12 Collar
13 Engine speed sensor
14 Stiffener
15 Air suction hose
16 Eyebolt
17 Air suction pipe
18 Eyebolt
19 Air outlet pipe
20 Eyebolt
21 Water outlet pipe
22 Eyebolt
23 Water inlet pipe
24 Eyebolt
25 Oil pipe
26 Air compressor
27 O-ring
28 Flywheel housing
: Locating pin
: Non-reusable parts
FLYWHEEL