Mitsubishi 6M70 - Injector

13-72
Removal: Mitsubishi 6M70 Injector
• Tighten the nut so that a hook of can be hung on section A
of the injector.
• Attach to and remove the injector.
Installation procedure
•
Installation: Mitsubishi 6M70 Injection pipe
Apply (width across flats
: 24 mm) to the connector of the
injector as a stopper.
CAUTION
• Do not use except for a stopper of the injection pipe,
otherwise the open end section may be broken.
• Ensure that the pipe and mounting surfaces of the connector are
flat and free from damage.
• Bring the pipe into intimate contact with mounting surfaces of the
connector evenly, and temporarily tighten it without applying an
excessive force.
• Tighten it to the specified torque after temporary tightening.
INJECTOR