14-18
Radiator
Disassembly sequence
CAUTION
• Gently handle upper tank and lower tank, since they are made of a resin that can break on impact.
• If there are two paint marks on the joint between the core and upper tank or on the joint between the core
and lower tank (which indicates that the tank retaining tabs have been crimped twice before), replace the
core with a new part.
• Do not disassemble radiator unless there is an abnormality.
Assembly sequence
Follow the disassembly sequence in reverse.
Service standards
Tightening torque (Unit: N·m {kgf·m})
Location Maintenance item Standard value Limit Remedy
–
Air leakage from radiator
(air pressure: 177 kPa {1.8 kgf/cm
2
})
0 cm
3
{0 mL} – Rectify or replace
Mark Parts to be tightened Tightening torque Remarks
Drain cock 2 {0.2} –
Bolt (side member mounting) 13 {1.3} –
1 Thrust rod bracket
2 Radiator shroud
3 Cross stay
4 Drain cock
5 Side member
6 Upper tank
7 Packing
8 Lower tank
9 Packing
10 Core
: Non-reusable parts
RADIATOR AND FAN SHROUD
To Next Page
Loading...
