11
11-23
Removal procedure
Removal: Engine
• Hook a lifting device onto front hanger, rear hanger RH and rear
hanger LH, and lift the device with a crane until it is taut.
WARNING
• Use a lifting device that can comfortably withstand the
mass of the engine (approx. 1000 kg).
• Ensure that the harnesses, piping and other relevant parts have
been disconnected.
• Remove the bolts and nuts from the engine mounts. Slowly lift
the engine, taking care not to hit the engine against the frame or
cab.
• Once the bottom of the engine is out of the frame, turn the en-
gine by 90° and remove it out of the vehicle.
Inspection procedure
Inspection: Mounting
• Check the entire circumference of the rubber cushion of the
mountings for a crack, breakage and adhesion of oil.
• If there is any abnormality, replace the mounting.
To Next Page
Loading...
