11-24
Installation procedure
Installation: Rear mounting
• Install the rear mounting on the engine in the illustrated direc-
tion.
Installation: Engine
• Loosen cross member and support mounting bolts and nuts.
• Hook a lifting device onto front hanger, rear hanger RH and rear
hanger LH, and lift the device with a crane to install the engine.
• Make sure that the stud of the rear mounting is placed at the il-
lustrated position (lowermost part of the slot on the support
side).
• The slot on the cross member side needs not necessarily be on
the lowermost part.
• If the stud is not placed at the illustrated position, adjust the posi-
tion with the cross member and support.
• Tighten cross member and support mounting bolts and nuts to
the torque of 120 to 160 N·m {12 to 16 kgf·m}.
• Tighten front and rear mounting nuts to the specified torque.
ENGINE REMOVAL AND INSTALLATION
To Next Page
Loading...
