Mitsubishi 6M70 - Thermostat Disassembly and Assembly

14-34
Disassembly sequence
• Do not remove the thermostat case unless it has a water leak or any other defect.
Installation sequence
Follow the disassembly sequence in reverse.
• Refer to the previous section “DISCONNECTION AND CONNECTION OF HOSES AND PIPES” for the correct
insertion depth of thermostat cover and case hoses into the pump as well as the correct tightening torque of
clamps.
1 Water hose
2 Bypass pipe
3 O-ring
4 Eyebolt
5 Air bleeding pipe
6 Thermostat cover
7 Rubber ring
8 Thermostat
(Valve opening temperature
82°C)
9 Thermostat
(Valve opening temperature
88°C)
10 Water temperature sensor
(for engine control)
11 Water temperature sensor
<for thermometer>
12 Overheat switch
13 Water joint
14 Thermostat case
15 Gasket
: Non-reusable parts
MITSUBISHI 6M70 THERMOSTAT
M
itsubishi 6M70 Engine Parts contact:
email: EngineParts@HeavyEquipmentRestorationParts.com
Phone: 269 673 1638