11-74
Inspection before removal
Inspection: Flywheel friction surface runout when fitted
• If the measurement exceeds the limit, check if the bolts are cor-
rectly tightened as well as the crankshaft mounting surface. Cor-
rect or replace the flywheel as required.
Removal procedure
Removal: Flywheel
• To remove the flywheel, use bolts inserted into the dedicated
holes in the flywheel.
Removal: Ring gear
• Heat the ring gear evenly with a gas burner or the like until it
reaches approximately 200°C, then remove it from the flywheel.
WARNING
• You may burn yourself if you touch the heated ring gear.
Removal: Collar
• Install bolts (M4 x 0.7 mm) into the dedicated holes in the collar,
and pull the bolts to remove the collar.
Inspection procedure
Inspection: Flywheel
(1) Friction surface height
• If the measurement exceeds the limit, replace the flywheel.
FLYWHEEL
To Next Page
Loading...
