11
11-73
Service standards (Unit: mm)
Tightening torque (Unit: N·m {kgf·m})
Lubricant and/or sealant
Special tools
Location Maintenance item Standard value Limit Remedy
4 Flywheel
Friction surface distortion 0.05 0.2
Rectify or
replace
Friction surface height 48 ± 0.2 49.5 Replace
Friction surface runout
(when fitted)
–0.2
Rectify or
replace
Friction surface parallelism 0.1 or less –
Rectify or
replace
28
Eccentricity of flywheel housing measured at spigot joint sec-
tion (when fitted)
–0.2
Inspect or
replace
Mark Parts to be tightened Tightening torque Remarks
Bolt (flywheel mounting)
Without PTO 100 {10} + 90°
• Wet
• Can be reused
up to 3 times
With PTO 100 {10} + 150°
Power steering oil hose 68 {7.0} –
Bolt (power steering oil pump mounting) 74 {7.5} –
Nut (collar mounting) 100 {10} –
Engine speed sensor 25 {2.5} –
Bolt (rear oil seal mounting) 12 {1.2} –
Bolt (flywheel housing mounting) 80 {8.0} –
Eyebolt (oil pipe mounting) 21 {2.1} –
Eyebolt (air outlet pipe mounting) 100 {10} –
Eyebolt (water inlet pipe mounting)
50 {5.1} –
Eyebolt (water outlet pipe mounting)
Eyebolt (air suction pipe mounting) 155 {16} –
Mark Points of application Specified lubricant and/or sealant Quantity
Thread of bolts
Engine oil As requiredO-ring
Rear oil seal lip
Rear oil seal surface to be mated with flywheel housing
ThreeBond 1207C As required
Engine mounting surface of flywheel housing
Mark Tool name and shape Part No. Application
Socket wrench ME350193
Installation of flywheel
Magnet base MH062356
To Next Page
Loading...
