EasyManua.ls Logo

Mitsubishi 6M70 - Page 183

Mitsubishi 6M70
364 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
13-51
71 Starter SW (S) ON/OFF
Engine cranked by means of starter
switch
ON
Starter switch in position except
START
OFF
72 Starter SW (M) ON/OFF
Starter switch in ON position ON
Starter switch in position except ON OFF
73 Accel SW ON/OFF
Accelerator pedal not pressed ON
Accelerator pedal pressed OFF
74 Powertard SW 1 ON/OFF
Powertard switch (1st step): ON ON
Powertard switch (1st step): OFF OFF
75 Powertard SW 2 ON/OFF
Powertard switch (2nd step): ON ON
Powertard switch (2nd step): OFF OFF
76 Clutch SW ON/OFF
Clutch pedal pressed ON
Clutch pedal not pressed OFF
77 Neutral SW ON/OFF
Transmission not in neutral ON
Transmission in neutral OFF
78 Idle Up Cancel SW ON/OFF
Actuator test is performed
ON (5 times, for 1.5 sec.
each)
Actuator test is not performed OFF
[Actuator test] B8: Idle Up Cancel SW
7C PTO SW ON/OFF
Governor control switch ON ON
Governor control switch OFF OFF
7D Diagnosis SW ON/OFF
Diagnosis switch OFF
(with connector connected)
ON
Diagnosis switch ON
(with connector disconnected)
OFF
7E Memory Clear SW ON/OFF
Memory clear switch OFF
(with connector connected)
ON
Memory clear switch ON
(with connector disconnected)
OFF
7F Auxiliary Brake SW 1 ON/OFF
Operated under following conditions
Accelerator and clutch pedals are
pressed
Transmission in neutral position
ON
Other than above conditions OFF
80 Powertard M/V ON/OFF
Powertard operating ON
Powertard not operating OFF
[Actuator test] A6: Powertard M/V
82 VGT M/V 1 ON/OFF See Gr15.
83 VGT M/V 2 ON/OFF See Gr15.
84 VGT M/V 3 ON/OFF See Gr15.
85 Auxiliary Brake Indicator Lamp ON/OFF
Auxiliary brake operating ON
Auxiliary brake not operating OFF
[Actuator test] AE: Auxiliary Brake Indicator Lamp
88 Starter Safety Relay ON/OFF See Gr54.
89 EDU Power Relay ON/OFF See Gr17.
8A MIL LAMP ON/OFF
Starter switch ON (engine not started) ON
No error after engine startup OFF
[Actuator test] B3: MIL Lamp
8B Diagnosis Lamp ON/OFF
Starter switch ON (engine not started) ON
No error after engine startup OFF
[Actuator test] B4: Diagnosis Lamp
No. Item Data Inspection condition Requirement

Table of Contents

Related product manuals