13
13-55
Check item Measurement method
Resistance of water temperature sensor
[Conditions]
• Starter switch OFF
• Disconnect connector. Perform inspection on vehicle-side connector.
[Requirements]
Terminals: A40-A41
• 20°C: 2.45 ± 0.14 kΩ
• 80°C: 0.32 kΩ (reference value)
• 110°C: 147.1 ± 2 kΩ
Output voltage of accelerator pedal position
sensor
[Conditions]
• Starter switch ON
• Vehicle-side harness connected (Perform inspection on back of connector.)
[Requirements]
Terminals (+)-(–):
B34-B33 (accelerator pedal position sensor 1)
B46-B45 (accelerator pedal position sensor 2)
• With accelerator pedal not pressed: 0.85 ± 0.1 V
• With accelerator pedal pressed: 4.15 ± 0.1 V
Resistance of fuel temperature sensor
[Conditions]
• Starter switch OFF
• Disconnect connector. Perform inspection on vehicle-side connector.
[Requirements]
Terminals: A89-A65
• 20°C: 2.5 ± 0.25 kΩ
• 80°C: 0.32 ± 0.02 kΩ
• 110°C: 0.144 ± 0.01 kΩ
Resistance of injector magnetic valve
[Conditions]
• Starter switch OFF
• Disconnect connector. Perform inspection on vehicle-side connector.
[Requirements]
Terminals:
A72-A23 (injector magnetic valve: No. 1 cylinder)
A70-A22 (injector magnetic valve: No. 2 cylinder)
A71-A46 (injector magnetic valve: No. 3 cylinder)
A94-A47 (injector magnetic valve: No. 4 cylinder)
A96-A24 (injector magnetic valve: No. 5 cylinder)
A95-A48 (injector magnetic valve: No. 6 cylinder)
• 0.21 to 0.295 Ω
Output voltage of Power take-off load sensor
[Conditions]
• Starter switch ON
• Vehicle-side harness connected (Perform inspection on back of connec-
tor.)
[Requirements]
Terminals (+)-(–): A15-A16
• Idling: 0.85 ± 0.1 V
• Full-load: 3.0 ± 0.1 V
Resistance of engine speed sensor
[Conditions]
• Starter switch OFF
• Disconnect connector. Perform inspection on vehicle-side connector.
[Requirements]
Terminals: A10-A9
• 2.2 ± 0.2 Ω (25°C)
Resistance of cylinder recognition sensor
[Conditions]
• Starter switch OFF
• Disconnect connector. Perform inspection on vehicle-side connector.
[Requirements]
Terminals: A59-A83
• 860 ± 86 Ω
Output voltage of vehicle speed sensor
[Conditions]
• Starter switch ON
• Vehicle-side harness connected (Perform inspection on back of connector.)
• Turn wheels slowly using chassis dynamometer.
[Requirements]
Terminals (+)-(–): A67-chassis ground
• High pulse voltage: 8 ± 1 V
• Low pulse voltage: 0.5 V or lower
02
03
04
05
06
07
08
09
To Next Page
Loading...
