13
13-81
Removal procedure
Removal: Cover
• Loosen plugs A and B and then loosen the drain plug. Next, dis-
charge fuel from the water separator.
• Using , remove the cover.
WARNING
• Do not bring an open flame or heat near to fuel, which can
catch fire easily.
• Thoroughly wipe the surface clean of spilled fuel that could
otherwise lead to a fire.
CAUTION
• Use care not to damage the cover.
Installation procedure
Installation: Cover
• Clean the surface of the water separator body, against which O-
ring abuts, and the O-ring groove in the cover.
• Replace the filter element and O-ring with new parts.
• Apply a thin coat of engine oil to the O-ring. Install the O-ring
onto the case.
CAUTION
• The use of non-genuine filter elements will lead to engine
problems. Be sure to use only genuine parts.
• To help prevent fuel injection problems, keep the water sep-
arator and fuel hoses free from contamination.
To Next Page
Loading...
