13-86
Accelerator Link
Removal sequence
1 Accelerator pedal switch
2 Bushing
3 Accelerator link A
4 Bushing
5 Accelerator link B
6 Collar
7 Return spring
8 Bushing
9 Accelerator link bracket
: Non-reusable parts
Installation sequence
Follow the removal sequence in reverse.
Lubricant and/or sealant
Installation procedure
Installation: Accelerator pedal switch
• Place accelerator link B against the stopper.
• Place the push rod of the accelerator pedal switch against accel-
erator link B and install the accelerator pedal switch so that the
stroke of the push rod is to the dimension shown in the illustra-
tion.
Mark Points of application Specified lubricant and/or sealant Quantity
Sliding surfaces of bushing and accelerator link bracket
Chassis grease
[NLGI No. 1 (Li soap)]
As required
Sliding surfaces of collar and return spring
ENGINE CONTROL
To Next Page
Loading...
