13
13-91
#320 Inspection of Mitsubishi 6M70 cylinder recognition sensor
• Measure the resistance between terminals 1 and 2.
• If the measurement is out of specification, replace the sensor.
#323 Inspection of Mitsubishi 6M70 fuel temperature sensor
• Place the fuel temperature sensor in a container filled with en-
gine oil.
• Heat the oil to each of the specified temperatures. Stir the oil
well while doing so.
• Measure the resistance between terminals 1 and 2.
• If any measurement is out of specification, replace the sensor.
#324 Inspection of accelerator pedal position sensor
• Apply 5 volts DC to terminals 4 and 6 and terminals 1 and 3 of
the accelerator pedal position sensor connector.
• Measure the output voltage at terminals 5 and 6 (sensor 1) and
the output voltage at terminals 2 and 3 (sensor 2) with the lever
in each specified position.
A: Position in which accelerator pedal switch is fully pushed in
by lever
B: Position in which lever is touching stopper bolt
• If any output voltage is out of specification, make an adjustment.
• If any output voltage is still out of specification when you have
made an adjustment, replace the sensor.
#571 Inspection of Powertard solenoid valve
• Measure the resistance between terminals 1 and 2.
• If the measurement is out of specification, replace the Powertard
solenoid valve.
Standard value 860 ± 86 Ω
Standard value
20°C 2.5 ± 0.25
kΩ
80°C 0.32 ± 0.02 kΩ
110°C 0.144 ± 0.01 kΩ
Standard value
Lever position Output voltage
Idling position A 0.85 ± 0.1 V
Full load position B 4.15 ± 0.1 V
Standard value Engine oil temperature: 25°C 32.6 to 39.8 Ω
To Next Page
Loading...
