14-20
• Adjust the stopper bolt until the gap dimension shown in the il-
lustration is obtained on the attachment of .
CAUTION
• Before using , be sure to set the gap to the specified di-
mension by adjusting the stopper bolt. Otherwise, damaged
will result.
• Use to bend open tabs of retain tank in place.
• After tabs are bent open, squeeze the handle
of
to straight-
en tabs as illustrated.
• After straightening all tabs in the perimeter, hold the pipes con-
nected to the inlet/outlet, and remove tank.
• If it is difficult to remove tank lightly hit with rubber hammer (or
plastic hammer) to remove.
CAUTION
• Gently handle tanks, since they are made of a resin that can
break on impact.
Inspection procedure
Inspection: Tank surface where core is to be mounted
• Check and clean the tank surface where the core is to be mount-
ed for cleanliness, damage, etc.
• If any abnormality is found, replace the tank.
CAUTION
• To prevent adhesion of foreign substances on mounting
surface, conduct work with bare hands.
RADIATOR AND FAN SHROUD
To Next Page
Loading...
