17
17-15
6.1 Electronic control unit connector terminal layout
6.2 Inspection instructions
• Some inspections are performed with the connectors removed. Others are performed with the connectors fitted.
Observe the following caution:
CAUTION
• Do not touch any terminal except those specified for the inspection. Be particularly careful not to cause
short circuits between terminals using the tester probes.
Check item Measurement method
Resistance of intake air temperature sensor 1
[Conditions]
• Starter switch OFF
• Disconnect connector. Perform inspection on vehicle-side connector.
[Requirements]
Terminals: A63-A32
• 0°C: 15 kΩ
• 20°C: 6.514 kΩ
• 80°C: 0.874 kΩ
Voltage of electronic drive unit relay
[Conditions]
• Starter switch ON
• Vehicle-side harness connected (Perform inspection on back of connector.)
[Requirements]
Terminals (+)-(–): B14-ground
• With relay operating: 0 V
• With relay not operating: Corresponding to battery voltage
01
+3.78
–2.94
+1.437
–1.147
+0.136
–0.115
02
To Next Page
Loading...
