11
11-27
Disassembly sequence
Assembly sequence
Follow the disassembly sequence in reverse.
Tightening torque (Unit: N·m {kgf·m})
Lubricant and/or sealant
Work before removal
Releasing valve spring force
• Before loosening the rocker and shaft mounting bolts, check
whether the valve springs are compressed by the rockers. If so,
loosen the adjusting screws on the rockers to relieve the spring
force. This will eliminate the possibility of compressed springs
damaging parts when they are released.
Installation procedure
Installation: Packing
• Apply sealant over the periphery of the packing and immediately
install it on the rocker case.
• After installing it on the rocker case, apply sealant over the top of
the packing.
• Install the rocker gasket and rocker cover on it immediately after
applying sealant.
CAUTION
• Never run the engine for one hour after installation.
• If the rocker cover is removed after installation, never fail to
replace the packing and apply the sealant again.
Mark Parts to be tightened Tightening torque Remarks
Bolt (rocker cover mounting)
8.8 {0.9} 6.5 Ft Lbs
–
Oil pipe 44 {4.5} –
M10 bolt (slave piston housing mounting) 55 {5.5} –
Bolt (rocker shaft mounting) 98 {10} –
M12 bolt (slave piston housing mounting) 80 {8.0} –
Mark Points of application Specified lubricant and/or sealant Quantity
Rubber portion of oil filler cap
Engine oil As requiredO-ring
Rocker cover gasket
Periphery and top surface of packing ThreeBond 1211 As required
1 Oil filler cap
2 Rubber
3 Rocker cover
4 Rocker cover gasket
5 Packing
6 Oil pipe
7 Harness
8 Slave piston housing
9 Rocker shaft cap
10 Rocker and shaft
(See later section.)
11 Bushing connector
12 O-ring
*
a: Rocker case
: Locating pin
: Non-reusable parts
To Next Page
Loading...
