11
11-33
Installation procedure
Installation: Rocker case
• Remove oil or any other contamination from the surfaces where
sealant is to be applied.
• Apply sealant onto the areas (shown in the illustration) on the
top surfaces of the cylinder head and timing gear case. Take
care not to spread the sealant beyond the application areas dur-
ing installation.
• Within three minutes following the application, install the rocker
case together with the rocker case gasket on the cylinder head.
CAUTION
• Do not start the engine for at least an hour after installation.
• Whenever the rocker case mounting bolts are subsequently
loosened or removed, the rocker case gasket must be re-
placed and sealant reapplied upon reassembly.
Installation: Camshaft
• Make sure that each alignment mark is aligned.
• Install the camshaft such that the stamped line on the camshaft
gear is level with the top surface of the rocker case.
To Next Page
Loading...
