11
11-41
Removal: Idler shaft
• Remove the idler shaft together with idler gear D as a unit with a
slide hammer.
Removal: Cylinder head gasket
CAUTION
• Be careful not to scratch the cylinder head, crankcase and
flywheel housing when removing the cylinder head gasket.
Inspection procedure
Inspection: Clearance between idler shaft and idler gear
bushing
• If the measurement exceeds the limit, replace the bushing.
Replacement of idler gear bushing
[Removal]
[Installation]
• Press in the bushing unt
il
contacts the end face of idler
gear D.
• After installation, measure the clearance again.
• If the measurement is less than the specified value, ream the
bushing.
To Next Page
Loading...
