11
11-77
• Tighten the flywheel mounting bolts to a torque of 100 N·m {10
kgf·m}.
• Further tighten the bolts in the following procedure.
• Turn the holder
of
counterclockwise to preload the built-
in spring.
• Set the tool such that the rod (extension) is pressed against
by the force of the spring.
• Align any line on the holder scale with any line on the socket
scale. (This will be used as the reference point = 0°.)
• From the reference point, turn the socket by 90° <Without fly-
wheel PTO>, 150° <With flywheel PTO> clockwise. Each divi-
sion on the socket scale represents 5°.
• After tightening the bolt within the plastic region, make a
punch mark on the bolt head for subsequent identification.
CAUTION
• The bolts should be tightened within the plastic region.
Never tighten them further than the specified angle.
Mitsubishi 6M70 Engine Par
ts contact:
email: EngineParts@HeavyEquipmentRestorationParts.com
Phone: 269 673 1638
To Next Page
Loading...
