11
11-81
[Installation]
• Install until it contacts the idler gear with idler gear A, B fac-
ing in the illustrated direction.
• After installation, measure the clearance again.
• If the measurement is less than the standard value, ream the
bushing.
Installation procedure
Installation: idler gear
• Install idler gear A, B such that the alignment mark “A” on the
gear is aligned with the alignment mark “A” on the crankshaft
gear.
• When installing idler gear C, ensure that the alignment mark “B”
on the gear is aligned with the alignment mark “B” on idler gear
A, B and that the alignment mark “C” on idler gear C is aligned
with the alignment mark “C” on the supply pump gear.
To Next Page
Loading...
