11-86
Replacement of idler gear bushing
[Removal]
[Installation]
• Install until it contacts the idler gear with idler gear C facing
in the illustrated direction.
• After installation, measure the clearance again.
• If the measurement is less than the standard value, ream the
bushing.
Inspection: Clearance between idler gear bushing and idler
shaft A
[Inspection]
• If the clearance exceeds the limit, replace the bushing.
Replacement of idler gear bushing
[Removal]
[Installation]
• Install until it contacts the idler gear with idler gear A, B fac-
ing in the illustrated direction.
• After installation, measure the clearance again.
• If the measurement is less than the standard value, ream the
bushing.
TIMING GEARS <WITH FLYWHEEL PTO>
To Next Page
Loading...
