Mitsubishi FX1N Series Programming Manual

FX Series Programmable Controlers Applied Instructions 5
5-202
The following example writes the Run Command parameters to Inverter Station #1.
For2secondsafterthe
reset instruction is
transmitted, the inverter
does not accept
communication.
As this period of time is
controlled by the PLC,
the sequence does not
need to be taken into
consideration
Use EXTR K12/K13 to
read and write
parameters
Before parameter read/
write, link parameters are
automatically re-written
If a second parameter is
present, it is
automatically re-written
Note:
As parameters 9,10 11 and 12 are used for EXTR K12/13, DO NOT use them with EXTR K11/
K12.
EXTR K11 K1 HFA K2M64
EXTR K11 K1 HFC K9696

Mitsubishi FX1N Series Specifications

General

Programming Language	Ladder Logic
Output Type	Relay, Transistor
Operating Temperature	0 to 55°C
Power Supply	100-240V AC or 24V DC
Program Capacity	8K steps
Communication Ports	RS-422
Data Memory	8000 words
High-speed Counters	Up to 6 channels
Expansion Modules	Available
Pulse Output	2 points