Mitsubishi FX3UC Series User Manual

117
FX3UC Series Programmable Controllers
User’s Manual - Hardware Edition
3 Generic Specifications/Installation Work
3.8 Display module Installing / Removal (Only FX3UC-32MT-LT)
1
Outline
2
External Dimensions
3
Generic Specifications
4
Power Supply Specifications
5
Input Specifications
6
Output Specifications
7
Examples of Wiring for Various Uses
8
Terminal Block
9
CC-Link/LT Master FX
3UC
-LT only
10
Display module FX
3UC
-LT only
1
Outline
2
External Dimensions
3
Generic Specifications
4
Power Supply Specifications
5
Input Specifications
6
Output Specifications
7
Examples of Wiring for Various Uses
8
Terminal Block
9
CC-Link/LT Master FX
3UC
(LT only)
10
Display module FX
3UC
(LT only)
3.8 Display module Installing / Removal (Only FX3UC-32MT-LT)
The FX3UC-MT/D and FX3UC-MT/DSS do not support the display module.
3.8.1 Removal
1) Gently place the tip of a flat blade screwdriver to the Display module
fixing hooks (right fig.
c
).
2) Tilt the flat blade screwdriver at the two Display module fixing hooks to
lift the display module from the main unit by about 1mm (0.04") (right fig.
d
).
Carefully perform the above trying not to bend or break the Display
module fixing hooks.
3) Hold the display module (right fig.) and remove the display module.
3.8.2 Installing
1) Put the connector of the display module on the main unit (figure on
the right).
2) Push the display module to install it (
c
in the figure on the right).
Fixed
hook

Mitsubishi FX3UC Series Specifications

General

Brand	Mitsubishi
Model	FX3UC Series
Category	Controller
Language	English