Mitsubishi GOT1000 User Manual

6 - 6
6.5 Installation Procedure
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
PART NAME
5
EMC DIRECTIVE
6
INSTALLATION
7
WIRING
8
OPTION
6.5 Installation Procedure
The GOT is designed to be embedded into a panel.
Mount the GOT by following the procedure below.
For panel cutting dimensions, refer to Section 6.2.
Note that the panel thickness should be within 1 to 4mm.
1 Installing the packing
Install packing to the packing installation groove on
the back panel of the GOT.
2 Inserting into the panel face
Insert the GOT from the front side of the panel.
(Right drawing is the example of lateral format.)
3 Fixing the GOT
1) Insert the hooks on the mounting fittings (supplied) into the
mounting holes on the GOT unit.
2) Slide the mounting fittings to the back end.
3) Slide them to the left to lock them in place, and then fix them
with the mounting screws (supplied).
The GOT will be fixed in 4 upper/lower parts.
Tighten the mounting screw with the specified torque.
(Failure to do so may distort the panel and make a surface
waviness on the protective sheet.)
4 A protection film is attached on the display section of GOT prior to shipment.
Remove the film when the installation is completed.
Tightening torque 0.20 to 0.25 N•m
Packing
Packing installation groove
Packing
Magnified
illustration
Mounting hole
1)
3)
2)
Mounting
fitting
Mounting
screw
WWW.NNC.IR

Mitsubishi GOT1000 Specifications

General

Series	GOT1000
Power Supply	24 VDC
Type	HMI (Human Machine Interface)
Processor	RISC
Communication Interfaces	RS-232, USB
Storage Temperature	-20 to 60°C
Display Type	TFT LCD
Backlight Life	50, 000 hours
Operating Temperature	0 to 50 °C