Mitsubishi GOT1000 User Manual

15 - 1
15.1 About the OS
9
UTILITY FUNCTION
10
LANGUAGE SETTING
11
COMMUNICATION INTERFACE SETTING
12
DISPLAY AND OPERATION SETTINGS
13
CLOCK SETTING
14
FILE DISPLAY
15
OS INSTALLATION
16
MAINTENANCE AND INSPECTION
15. OS INSTALLATION
15.1 About the OS
GT10 is factory-installed with the BootOS, Standard monitor OS, and communication driver ([MELSEC-FX]).
Standard monitor OS is upgradeable from GT Designer2.
An installation of the communication driver is required when connected to a controller other than a MELSEC-FX.
(BootOS cannot be installed from GT Designer2.)
15.2 Standard monitor OS/
Communication Driver Installation
When installing the Standard monitor OS or communication driver, first bring up the OS installation screen on
the GOT, and then install the communication driver from GT Designer2.
1 Operation on the OS installation screen
1 Turn on the power while pressing and holding the
bottom right corner of the screen.
2 The OS installation screen will appear.
3 Install the Standard monitor OS and
communication driver from GT Designer2.
Refer to the chapter below for how to install the
Standard monitor OS and communication driver
from GT Designer2.
GT Designer2 Version
Basic Operation/Data Transfer Manual
(Chapter 8 TRANSFERRING DATA)
Turn the GOT
power on with
the lower right
corner touched.
WWW.NNC.IR

Mitsubishi GOT1000 Specifications

General

Series	GOT1000
Power Supply	24 VDC
Type	HMI (Human Machine Interface)
Processor	RISC
Communication Interfaces	RS-232, USB
Storage Temperature	-20 to 60°C
Display Type	TFT LCD
Backlight Life	50, 000 hours
Operating Temperature	0 to 50 °C