173
APPENDICES
A
Appendix 1 Details of I/O Signals
Appendix 1.2 Output signal
(3) Channel change request (YB)
Turn Channel change request (YB) OFF → ON → OFF to change a channel to perform the offset/gain setting.
For the timing of turning the signal OFF → ON → OFF, refer to the following.
• Channel change completed flag (XB) ( Page 167, Appendix 1.1)
(4) Maximum value/minimum value reset request (YD)
Turn Maximum value/minimum value reset request (YD) OFF → ON → OFF to clear the maximum or minimum
values stored in CH Maximum value (Un\G30, Un\G32, Un\G34, Un\G36) and CH Minimum value (Un\G31,
Un\G33, Un\G35, Un\G37).
For the timing of turning the signal OFF → ON → OFF, refer to the following.
• Maximum value/minimum value reset completed flag (XD) ( Page 167, Appendix 1.1)
(5) Error clear request (YF)
To clear Error flag (XF), Input signal error detection signal (XC), and Latest error code (Un\G19), turn Error clear
request (YF) OFF → ON → OFF.
For the timing of turning the signal OFF → ON → OFF, refer to the following.
• Input signal error detection signal (XC) ( Page 167, Appendix 1.1)
• Error flag (XF) ( Page 167, Appendix 1.1)
To Next Page
Loading...
Need help?
General
