Mitsubishi L Series - Chapter 10 Programming; Procedure for Programming

140
CHAPTER 10PROGRAMMING
This chapter describes the procedure for programming and the basic program of the A/D converter module.
10.1 Procedure for Programming
Create a program to execute A/D conversion, according to the following procedure.
NO
YES
Start
End
A/D conversion enable/disable program
Averaging processing setting program
Conversion speed setting program
Scaling function program*
1
Shift function program*
1
Digital clipping function program*
1
Difference conversion function program*
1
Logging function program*
1
Flow amount integration function program*
1
Input signal error detection function program*
1
Warning output function (process alarm) program*
1
Switch setting, parameter setting, and auto refresh setting
Error reset program
Use the configuration function?
(1) Initial setting program
(2) Auxiliary program*
2
Do the setting by using a program.
*1 A program that is created according to
the function to be used
*2 A program that is added according to the control
target (Create a program if needed.)
Initial setting
Program to read a digital output value, scaling value
(digital operation value, warning output flag (process
alarm), and input signal error detection flag
( )
( )
Page 141, Section 10.2
Page 141, Section 10.2