223
APPENDICES
A
Appendix 8 Differences with Q Series
Appendix 8 Differences with Q Series
The following describes the differences between L series and Q series, and the precautions for configuring the L-series
system using the Q-series program.
The description in this chapter is in the case of Q64AD.
(1) Specification comparison
The following table shows a comparison of the specifications between the L60AD4 and Q64AD.
Difference L60AD4 Q64AD
Resolution change
function
1 type; 1/20000 (resolution change function is not
installed)
2 types; normal resolution (1/4000) and high resolution
(1/12000 or 1/16000)
Average time
20μs: 2 to 1500ms
80μs, 1ms: 2 to 5000ms
2 to 5000ms
Averaging process
specification
Averaging process setting (used to replace Q64AD)
(Un\G9)
Averaging process setting (Un\G24)
Averaging process setting (used to replace Q64AD)
(Un\G9)
Intelligent function
module switch
setting
Digital output
value, scaling
value
When Operating condition setting request (Y9) is turned
from OFF to ON, digital values and scaling values are
held.
When Operating condition setting request (Y9) is turned
from OFF to ON, digital values are cleared. (Q64AD has
no scaling value.)
H
Fixed to 000H
0H
1H to FH (A value other than 0H)
: Normal resolution mode
: High resolution mode
H
00
H
01
H
to FF
H
(value other than 00
H
)
0
H
1
H
to F
H
(value other than 0
H
)
: Normal Resolution Mode
: High resolution mode
0
H
1
H
to F
H
(value other than 0
H
)
: Normal Resolution Mode
(A/D conversion processing)
: Offset/gain setting mode
: With temperature drift correction
:
Without temperature drift correction
To Next Page
Loading...
Need help?
General
