193
APPENDICES
A
Appendix 2 Details of Buffer Memory Addresses
(37)CH Trigger data (Un\G1064 to Un\G1067)
When the logging function is used, set the buffer memory address monitored for the occurrence condition of level
trigger.
For details on the logging function, refer to the following.
• Logging function ( Page 98, Section 8.14)
(a) Setting range
Setting range is 0 to 4999.
(b) Enabling the setting
Turn OFF → ON → OFF Operating condition setting request (Y9) to enable the setting.
(c) Default value
● In the channel where a value out of the above setting range is set, an error occurs. Then, the error code is stored in
Latest error code (Un\G19), Error flag (XF) is turned to ON and logging cannot be performed.
● Set CH Digital output value (Un\G11 to Un\G14), CH Scaling value (digital operation value) (Un\G54 to Un\G57),
Level data (Un\G1072 to Un\G1081), or a buffer memory address with "R" in List of Buffer Memory Addresses to the
trigger data.
Buffer memory address, system area, etc. with "R/W" or "W" in List of Buffer Memory Addresses
For details on the buffer memory address, refer to the following.
• List of buffer memory addresses ( Page 26, Section 3.5)
Channel Default value Buffer memory to be monitored
CH1 54 CH1 Scaling value (digital operation value) (Un\G54)
CH2 55 CH2 Scaling value (digital operation value) (Un\G55)
CH3 56 CH3 Scaling value (digital operation value) (Un\G56)
CH4 57 CH4 Scaling value (digital operation value) (Un\G57)
Ex.
To Next Page
Loading...
Need help?
General
