21
CHAPTER 3 SPECIFICATIONS
3
3.2 Performance Specifications
*3 Except when receiving noise influence.
*4 The default value is 80µs/channel.
*5 The logging function can be used only in the middle speed (80µs/channel) or low speed (1ms/channel).
*6 The flow amount integration function can be used only in the low speed (1ms/channel).
*7 This is a momentary current value which does not cause damage to internal resistors of the module. The maximum input
current value for constant application is 24mA.
*8 If the number of offset/gain settings exceeds 50000 times, an error occurs.
To Next Page
Loading...
