To Next Page

To Previous Page

REASSEMBLY OF BASIC ENGINE

7-21

4.11 Adjusting valve clearance

Adjust the valve clearance.

For adjusting procedures, refer to "Adjustment and

Operation."

Adjusting valve clearance

Timing mark

4.12 Installing rocker cover

(1)

Make sure that the gasket is firmly installed into the

rocker cover.

(2) Tighten the rocker cover mounting nuts to the specified

torque.

Installing rocker cover

4.13 Installing torque spring set

For installing procedures of the torque spring set, refer to

item "Installing Fuel System."



Mark on gear

case side

TDC mark on crankshaft

pulley side



Model Ignition order Rotation angle

.

.









Tightening torque

4.9 to 6.9 N㨯m

{0.5 to 0.7 kgf㨯m}

[3.6 to 5.1 lbf㨯ft]

Mitsubishi L2C Service Manual

Other manuals for Mitsubishi L2C