Mitsubishi L2C Service Manual

INLET AND EXHAUST SYSTEMS
11-3
2. Disassembling, inspecting and reassembling inlet and exhaust systems
2.1 Inspecting inlet cover and exhaust manifold
Inspecting inlet cover and exhaust manifold
2.2 Measuring distortion of inlet and exhaust
manifold
Using a straight edge and thickness gauges, measure
distortion across the cylinder head mounting surfaces of the
inlet cover and exhaust manifold. If the measured distortion
exceeds the limit, correct by grinding or replace the part.
Measuring distortion on inlet cover
Crack, damage
and corrosion
Crack, damage
and corrosion
Crack, damage,
contamination,
dirt adhesion and
corrosion
Crack, damage,
contamination,
dirt adhesion and
corrosion
Item Limit
Distortion on mounting surfaces of intake
cover and exhaust manifold
0.15 mm
[0.0059 in.]
Straight edge
Thickness gauge

Mitsubishi L2C Specifications

General

Brand	Mitsubishi
Model	L2C
Category	Engine
Language	English