Modification mode
[12]-23
3. Determining the block modification range (end point)
* Using Jog , , determine
the end point position.(E point)
* Press .
4. Setting the movement method and stitch length
When the end point is determined, the
presser will automatically return to the
start point. Take care when the needle
is lowered, etc.
* Set the movement method.
Press Add New Stitch To
Prior/Subsequent Data .
* Set the stitch length.
(Set to 3.0mm for this example.)
* Press .
5. Determining the movement amount
* Using the arrow keys, determine the
movement amount. (Move to the
position (point D').)
* Press .
(The block position will be modified.)
The presser will move. (The presse
To Next Page
Loading...
Need help?
General
